QUESTION 181 One of your trainees wants to know what values are used to elect the root bridge in a spanning tree topology. What can you tell her? (Select two options.)
A. The BPDU version number
B. The access layer bridge setting
C. The Bridge ID
D. The spanning-tree update number
E. The bridge priority
F. The VLAN number Answer: C, E
QUESTION 182 Which of the following are the routing protocols that are capable of supporting a network that uses VLSM and route summarization? (Select three options.)
A. IGRP
B. EIGRP
C. RIP v1
D. RIP v2
E. OSPF
F. VTP
G. LSA Answer: B, D, E
QUESTION 183 On the left are access list conditions and on the right design goals. Match up the corresponding pairs. (Please note: Not all options are used) Answer:
QUESTION 184 You are the network administrator. Your aim is to support a multi-protocol network that includes IP, AppleTalk and IPX. Which routing protocol can you use that will achieve this aim?
A. OSPF
B. EIGRP
C. RIP v2
D. IGRP
E. RIP v1 Answer: B
QUESTION 185 Which one of the following represents the bandwidth capacity of a single ISDN BRI B channel?
A. 16kb/s
B. 64kb/s
C. 128kb/s
D. 144kb/s
E. 192kb/s
F. 256kb/s Answer: B
QUESTION 186 The Missouri office router is connected through its s0 interface to the Alabama Headquarters router s1 interface. The Alabama router has two LANs. Missouri users obtain Internet access through the Headquarters router. The network interfaces in the topology are addressed as follows: Missouri: e0 -192.168.35.17/28; s0- 192.168.35.33/28; Alabama: e0- 192.168.35.49/28 e1 - 192.168.35.65/28, s1 -192.168.35.34/28. The accounting server has the address of 192.168.35.66/28. Match the access list conditions on the left with the goals on the right. (Please note: Not all options on the left are used.)
QUESTION 187 You work as network administrator at Cisco Highway. There are three routers that are connected serially. All serial Links all tested to be OK. The routing protocol is single area OSPF. The Cisco Highway2 router was replaced yesterday since it broke down. The router replacement has caused problems. Routing tables are not correctly updated and some traffic between the sites are not routed. The routers are configured as follows: Cisco Highway1 E0: 192.168.3.1/24 S0: 172.16.10.5/30 Secret password: Cisco Highway Cisco Highway2 E0: 192.168.4.1/24 S0: 172.16.10.10/30 S1: 172.16.10.6/30 Secret password: Cisco Highway Cisco Highway3 E0: 192.168.5.1/24 S1: 172.16.10.9/30 Secret password: Cisco Highway Answer: Cisco Highway2#config Cisco Highway2(config)#no router ospf 2 Cisco Highway2(config)#router ospf 2 Cisco Highway2(config-rooter)#network 192.168.4.0 0.0.0.255 area 0 Cisco Highway2(config-rooter)#network 172.16.10.8 0.0.0.3 area 0 Cisco Highway2(config-rooter)#network 172.16.10.4 0.0.0.3 area 0 Cisco Highway2(config-rooter)#Ctrl-Z Cisco Highway2#copy running start Cisco Highway2#
QUESTION 188 Which of the following fields of frame is used by detection schemes to perform its function?
A. ERR
B. Flag
C. FCS
D. MTU
E. MAC
F. PDU Answer: C
QUESTION 189 Your company has been assigned the following IP address for its network: 199.141.27.0 Of subnet mask of 255.255.255.240 was selected to make provision for the LAN design. Which of the following addresses can be assigned to hosts on the resulting subnets? (Select three options.)
A. 199.141.27.126
B. 199.141.27.175
C. 199.141.27.33
D. 199.141.27.119
E. 199.141.27.208
F. 199.141.27.112 Answer: A, C, D
QUESTION 190 You have been asked to configure a default route. Which of the IOS commands mentioned below will accomplish this task? (Select two options.)
A. LTD(config)# ip route 0.0.0.0 0.0.0.0 192.168.15.36
B. LTD(config)# ip route 0.0.0.0 192.168.15.36 255.255.255.255
C. LTD# ip default-network 0.0.0.0 192.168.15.36 255.255.255.255
D. LTD(config)# ip route 0.0.0.0 0.0.0.0 E0
E. LTD(config)# ip route 0.0.0.0 255.255.255.255 S0
F. LTD(config-router)# ip route 255.255.255.255 0.0.0.0 192.168.15.36 Answer: A, D
